I tried a different technique on this board which I thought would save some time. Well it did get the build off to a fast start but it left me with these gaps between the planks which will not be water tight.
So, while I saved some time up front, I now have to go back and fill in these gaps. Pay me now or pay me later…
I fixed this by mixing up some epoxy thickened with wood flour and troweled the mixture into the gaps.
Once I sand this back it will look awsome and the end result will be exactly the same as if I had done it the “regular” way.
Net result is that I didn’t gain any time but i guess i didn’t lose much either.
(note: I’m closing comments on this post because I’m getting a lot of spam on it. If you have a legit comment, just use a later post. Thanks.)
