I cut out the plan shape in preparation for the top deck to go on. Once that is complete its on to the rail shaping marathon!
Now that the galleries that were slowing things down have moved a bit farther down the list I’m opening up each page to show the five most recent posts instead of…
I now have the bottom deck and the two inner layers in place. As with the Mini Pintail, I will cut the board shape out of these layers before I…
Here I’ve added the last of the additional internal supports as mentioned earlier. You can see that I’ve cut out the outline of the board before I applied the final layer…
Here is the second internal layer going on. I will add a few more supports to this layer as I did to the first for the same reason.
I decided to add a couple of additional supports to the internal frame. I inadvertently mounted the inner frame with the slats running in the same direction as the slats…
Its been I little while since I’ve done any work on this board because I’ve been distracted with yet another new build (The Ozzy). I just can’t build fast enough…
Got the first deck panel glued up finally. I decided to use the CA glue as an assistant in this case but in the long run It wasn’t really necessary…
This board is going together like a dream. I’ve got both internal frames “pre-glued” with CA instant glue. The second frame went together in less than an hour using only…
