This was dubbed The Bonus Board because it was constructed entirely from off cuts of previous builds. I guess you could say it is a second generation Squalyboard. It is…
Next step is to cut out the frames. I start out by working up a design in AkuShaper. After tweaking the design until I get it just right I save…
Well it’s been a while but I’m back at it and glad to be! I’ve had a batch of wood piled in my shop for ages now. Some tongue and…
This was an experimental build to test out a variation of the parallel profile method using a type of wood that is cheap and plentiful. The experiment was a success…
Summer’s finally here and I’m desperate to get this bad boy in the water! I didn’t stop long enough to get any new pics up but the repair is going…
Well it’s been a long winter and now its time to start wrapping up all of those projects I’ve been neglecting. So back to work on this one and DISASTER!!!…
Once the epoxy set up on the fins, I sanded down the excess and then laid a sheet of fiberglass over each one for reinforcement. I won’t use fiberglass on…
I just realized that I never created a page for this board. It’s a variation of a Hawaiian Paipo more commonly know in these parts as a body board or…
Today I mounted the fins on this board. I set the toe in to two inches ahead of the tip and cut the mounting grooves with my dremmel tool. I set about…
It’s been a while since I’ve done any work on this board. Today I started to get things moving again. I started off by spending some time setting up the…
I’ve been busy making fins for all of the boards that I have in progress and this is one of them. The concept of this board has been “scrap wood…
Started working on some fins. I’m using the same lath wood that I used on the rest of this board to make fins. I glued the slats together with thickened…
