I spent some time with the belt sander and cleaned up the lines. I also began working on the rail bands. This forms the basis for the rail profile. I’ll…
I cut out the plan shape in preparation for the top deck to go on. Once that is complete its on to the rail shaping marathon!
I now have the bottom deck and the two inner layers in place. As with the Mini Pintail, I will cut the board shape out of these layers before I…
Here I’ve added the last of the additional internal supports as mentioned earlier. You can see that I’ve cut out the outline of the board before I applied the final layer…
Here is the second internal layer going on. I will add a few more supports to this layer as I did to the first for the same reason.
I decided to add a couple of additional supports to the internal frame. I inadvertently mounted the inner frame with the slats running in the same direction as the slats…
Its been I little while since I’ve done any work on this board because I’ve been distracted with yet another new build (The Ozzy). I just can’t build fast enough…
Got the first deck panel glued up finally. I decided to use the CA glue as an assistant in this case but in the long run It wasn’t really necessary…
This board is going together like a dream. I’ve got both internal frames “pre-glued” with CA instant glue. The second frame went together in less than an hour using only…
As I mentioned before I am using CA instant glue to glue up the frame as I cut each piece. I hope this works out well because I am really…
This will be another parallel profile board. It is still in the infant stages so far and I haven’t even gotten a photo of it yet. There are a couple of…
With the two internal frames all cut out its time to glue them together. Here they are laid out on a plastic drop cloth, the joints are filled with epoxy thickened…
